What type of plumber’s snake is used to uncover the drain of a washing machine?
September 21, 2017
A plumber’s snake is the common name of a drill hole, which is an element plumbing used to reach blockages in pipes and drains and open them. If the water stagnates in the drain used by your washing machine, drainage probably blocked or has a deeper within the main line obstruction. Uses a type different from snake to remove each different type of blockage in the drainage.
Snakes for the drainage of a washing machine
Check other drains of the house, like the kitchen and the bathroom sink, to check also stagnate. If the drain of the washing machine is the only drain in the house that is sealed or that is clogged, the biggest culprit of blocking this pipe will probably be soap scum. Use a small snake operated by a wire or a small electric snake. The minimum outlet size of a washing machine is 1 1/2 inches, so you should use a snake with a cable size that can pass through there, such as a 3/8 inch 9.52 mm) or 1/2 inch (1.27 cm).
Uncovering procedure with snake
To reach the drain pipe of the washing machine, switch off the washing machine and remove it from the wall. Remove the drain hose from the top of the drain spout. Before using the snake, be sure to wear personal protective equipment such as gloves and safety glasses.
Put the snake side of the cable into the drain pipe and turn on the snake’s power or hand-tighten the crank to cause the cable to go down the drain, around the load curve. Once the snake cord is fully extended, carefully pull it back out of the drain. Put the washing machine hose back in position and plug in the washer. Fill the washer with a small amount of water and let it drain while controlling that it is not sealed.
Snake for main drainage
If other elements, such as sinks and tubs, also experience drainage problems at the same time as the washing machine, it uses an electric snake in a drain at the end of a drainage mouth, usually at the base of the main pipe. Be careful when you remove the drain plug and have a bucket ready in case it overflows water. You can also use a hand snake, but it takes more effort on your part than if you use an electric snake.
Snake for floor drainage
If you have a clogged floor drain that receives water from the washing machine, use an electric snake. After removing the filter covering the drain mouth, check if you can see a cleaning plug underneath. If there is, remove the plug and insert the cable of the snake by this pipe, avoiding the curved trap. When you see that the snake motor indicates that the cable encounters resistance, put the cable in reverse for a few centimeters, and then re-tighten it to go down the pipe. Continue with this procedure until the cable overcomes the obstruction, and recovers the cable from the pipe. Pour several buckets of hot water through the drain to make sure the pipe is clean.